2011 Dodge Journey Owner Manual - Page 263

UNDERSTANDING YOUR INSTRUMENT PANEL 261 • Each time the ignition is turned to ON/RUN, the ESC to switch the headlights to high beam, and pull toward system will be ON, even if it was turned off previously. yourself (normal position) to return to low beam. • The ESC system will make buzzing or clicking sounds 7. Front Fog Light Indicator - If Equipped This indicator will illuminate when the front fog when it is active. This is normal; the sounds will stop lights are on. when ESC becomes inactive following the maneuver that caused the ESC activation. 8. Electronic Vehicle Information Center (EVIC) 5. Turn Signal Indicators Display The arrow will flash with the exterior turn signal Odometer when the turn signal lever is operated. The odometer display shows the total distance the veIf the vehicle electronics sense that the vehicle is driven hicle has been driven. more than 1 mile (1.6 km) with either turn signal on, a U.S. Federal regulations require that upon transfer of continuous chime will sound to alert you to turn the vehicle ownership, the seller certify to the purchaser the signals off. If either indicator flashes at a rapid rate, check correct mileage that the vehicle has been driven. If your for a defective outside light bulb. odometer needs to be repaired or serviced, the repair 6. High Beam Indicator technician should leave the odometer reading the same This indicator shows that the high beam head- as it was before the repair or service. If s/he cannot do so, lights are on. Push the multifunction lever forward then the odometer must be set at zero, and a sticker must 4