2012 Dodge Durango Owner Manual - Page 544
2012 Dodge Durango Manual
Page 544 highlights
542 STARTING AND OPERATING message will not be present, and a pressure value will be message is then followed by a graphic display, with displayed instead of dashes. A system fault can occur by pressure values still shown. This indicates the pressure values are still being received from the TPM Sensors but any of the following: they may not be located in the correct vehicle position. 1. Jamming due to electronic devices or driving next to However, the system still needs to be serviced as long as facilities emitting the same Radio Frequencies as the TPM the ЉSERVICE TPM SYSTEMЉ message exists. sensors. NOTE: 2. Installing some form of aftermarket window tinting • If your vehicle is equipped with a matching full-size that affects radio wave signals. spare wheel and tire assembly, it has a tire pressure monitoring sensor, and can be monitored by the Tire 3. Lots of snow or ice around the wheels or wheel Pressure Monitoring System (TPMS). In the event that housings. the matching full-size spare tire is swapped with a low 4. Using tire chains on the vehicle. pressure road tire, the next ignition switch cycle will still show the "Tire Pressure Monitoring Telltale Light" 5. Using wheels/tires not equipped with TPM sensors. to be ON, a chime to sound, a "LOW TIRE PRESThe EVIC will also display a ЉSERVICE TPM SYSTEMЉ SURE" message to appear in the EVIC, and the message for a minimum of five seconds when a system graphic display will still show the low tire pressure fault is detected possibly related to an incorrect sensor value "flashing." Driving the vehicle for up to 20 minlocation fault. In this case, the ЉSERVICE TPM SYSTEMЉ utes above 15 mph (24 km/h) will turn OFF the "Tire