2012 Dodge Journey Owner Manual - Page 54

52 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE As a guide, if you are shorter than average you will prefer a lower position and if you are taller than average you will prefer a higher position. When you release the anchorage try to move it up and down to make sure that it is locked in position. 3. Slide the latch plate upward over the folded webbing. The folded webbing must enter the slot at the top of the latch plate. 4. Continue to slide the latch plate up until it clears the folded webbing. In the rear seat, move toward the center of the seat to Seat Belts In Passenger Seating Positions position the belt away from your neck. The seat belts in the passenger seating positions are Lap/Shoulder Belt Untwisting Procedure equipped an Automatic Locking Retractor (ALR) or a Use the following procedure to untwist a twisted lap/ cinching latch plate which are used to secure a child shoulder belt. restraint system. For additional information, refer to "Installing Child Restraints Using The Vehicle Seat Belt" 1. Position the latch plate as close as possible to the under the "Child Restraints" section. The chart below anchor point. defines the type of feature for each seating position. 2. At about 6 to 12 in (15 to 30 cm) above the latch plate, Driver Center Passenger grasp and twist the belt webbing 180 degrees to create a First Row N/A N/A ALR fold that begins immediately above the latch plate. Second Row ALR Cinch ALR Third Row ALR N/A ALR