2014 Dodge Avenger Owner Manual - Page 20

18 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 2. Insert the first valid key into the ignition switch. Turn the ignition switch to the ON/RUN position for at least 3 seconds, but no longer than 15 seconds. Then, turn the ignition switch to the LOCK position and remove the first key. The new Sentry Key® is programmed. The Remote Keyless Entry (RKE) transmitter will also be programmed during this procedure. Repeat this procedure to program up to eight keys. If you do not have a programmed Sentry Key®, contact your 3. Insert the second valid key into the ignition switch. authorized dealer for details. Turn the ignition switch to the ON/RUN position NOTE: If a programmed key is lost, see your authorized within 15 seconds. After 10 seconds, a chime will dealer to have all remaining keys erased from the syssound. In addition, the Vehicle Security Light will tems memory. This will prevent the lost key from starting begin to flash. Turn the ignition switch to the LOCK your vehicle. The remaining keys must then be reproposition and remove the second key. grammed. All vehicle keys must be taken to an autho4. Insert a blank Sentry Key® into the ignition switch. Turn the ignition switch to the ON/RUN position within 60 seconds. After 10 seconds, a single chime will sound. In addition, the Vehicle Security Light will stop flashing. To indicate that programming is complete, the Vehicle Security Light will turn on again for three seconds and then turn off. rized dealer at the time of service to be reprogrammed. General Information The Sentry Key® system complies with FCC rules part 15 and with RSS-210 of Industry Canada. Operation is subject to the following conditions: • This device may not cause harmful interference.