2014 Dodge Avenger Owner Manual - Page 368

366 STARTING AND OPERATING The EVIC will also display a ЉCHECK TPM SYSTEMЉ message for a minimum of five seconds when a system fault related to an incorrect sensor location fault is detected. In this case, the ЉCHECK TPM SYSTEMЉ message is then followed with a graphic display with pressure values still shown. This indicates that the pressure values are still being received from the TPM sensors but 1. Jamming due to electronic devices or driving next to they may not be located in the correct vehicle position. facilities emitting the same Radio Frequencies as the The system still needs to be serviced as long as the ЉCHECK TPM SYSTEMЉ message is displayed. TPM sensors. If the ignition key is cycled, this sequence will repeat, providing the system fault still exists. If the system fault no longer exists, the "Tire Pressure Monitoring Telltale Light" will no longer flash, and the ЉCHECK TPM SYSTEMЉ message will no longer display, and a pressure value will display in place of the dashes. A system fault can occur due to any of the following: 2. Installing some form of aftermarket window tinting NOTE: that affects radio wave signals. 1. The compact spare tire (if so equipped) does not have a tire pressure monitoring sensor. Therefore, the TPMS 3. Lots of snow or ice around the wheels or wheel will not monitor the pressure in the compact spare tire. housings. 4. Using tire chains on the vehicle. 5. Using wheels/tires not equipped with TPM sensors. 2. If you install the compact spare tire in place of a road tire that has a pressure below the low-pressure warning limit, upon the next ignition key cycle, the "Tire Pressure Monitoring Telltale Light" will remain ON, a