2015 Ford Fusion Energi Owner Manual Printing 1 - Page 175

High Voltage Battery Charge (green light) - indicates status of charging: • No light means you have not connected the cord to the vehicle. • Blinking light means that the charging is in process. • Solid light means you have connected the cord, but the vehicle is not charging. Fault (red triangle light) - Lights up in case of a detected failure. No charging is possible: • Blinking red triangle light - means that the 120 volt convenience cord is trying to reset the failure and could restart the charging cycle. • Solid red triangle light - means that the fault is permanent. You need to unplug the cord and then plug it back in to reset the fault. If the fault persists, contact an authorized dealer. Charge Port The charge port is located between the front left side door and front left wheel well. There is an indentation located on the charge port door. Press with your thumb to press to open and close the door. The light ring located around the charge port indicates the charge status of the high voltage battery in your vehicle. Divided into four quadrants, the charge port light ring displays the state of charge in 25 percent increments. There is a cord acknowledgment feature that activates when you initiate a charge cycle. The four light quadrants will each individually flash clockwise starting with the top right light and ending with the top left, two full times, confirming the system detects the charging coupler. Use the key fob to view the charge status of your vehicle at any time by pressing the unlock button. The light ring will light up the corresponding quadrant(s) so that the current state of charge can be determined. If the charge is below 25 percent, the light ring will not light. Do not forget to press the lock button on your key fob to re-lock your vehicle. The light ring will also display the current state of charge when opening the doors. Charging Note: Your vehicle must be in park P to charge. To charge the high-voltage battery: Put the vehicle in park P and power down the vehicle. 2. With your thumb, press in and release the indentation located on the charge port door and the door will rotate open. 3. Plug the charging coupler into the charge port receptacle on your vehicle. Make sure the button clicks confirming that you have completely engaged the coupler. 1. E144779 Note: Do not force the charge port door open or closed. Forcing the door open or closed will damage the charge port. 172 Fusion/Mondeo (CC7), enUSA