2015 Ford Fusion Energi Owner Manual Printing 1 - Page 95

Instrument Cluster Service Engine Soon If the service engine soon indicator light stays lit after the you start the engine, it indicates that the On Board Diagnostics system (OBD) has detected a malfunction of the vehicle emissions control system. Refer to On board diagnostics (OBD) in the Fuel and Refueling chapter for more information about servicing your vehicle. See Emission Control System (page 166). If the light is blinking, the engine is misfiring. This could damage your catalytic converter. Drive in a moderate fashion (avoid heavy acceleration and deceleration) and have an authorized dealer service your vehicle immediately. Note: If your engine is misfiring, excessive exhaust temperatures can damage the catalytic converter or other vehicle components. The service engine soon indicator lights when the you first switch on your vehicle, prior to engine start, to check the bulb and to indicate whether the vehicle is ready for inspection maintenance testing. Normally, the service engine soon light will stay on until the engine cranks, then turn itself off if no malfunctions are present. However, if after 15 seconds the service engine soon light blinks eight times, it means that the vehicle is not ready for inspection maintenance testing. See Emission Control System (page 166). Stability Control Off Lights when you switch the system off. It will go out when you switch the system back on or when you switch off the ignition. See Using Stability Control (page 185). Stop Safely Lights if your vehicle has an electrical component fault or failure that will cause your vehicle to shutdown or enter into a limited operating mode. You may also see a message. E144693 Trunk Ajar Lights when the ignition is on and the trunk is not completely closed. E159323 Vehicle Plugged in (If Equipped) Lights when the vehicle is plugged in. A corresponding message may display after attempting to start the vehicle. E144694 AUDIBLE WARNINGS AND INDICATORS Key in Ignition Warning Chime Sounds when you open the driver's door and you have left the key in the ignition with it in the off or accessory position. Stability Control Flashes when the system is active. If it stays lit or does not E138639 light when you switch on the ignition, this indicates a malfunction. During a malfunction the system will switch off. Have an authorized dealer check the system immediately. See Using Stability Control (page 185). Keyless Warning Alert (If Equipped) Sounds the horn twice when you exit your vehicle with the intelligent access key, after the last door is closed and your keyless vehicle is in RUN, indicating your vehicle is still on. 92 Fusion/Mondeo (CC7), enUSA