2015 Ford Fusion Energi Owner Manual Printing 1 - Page 177
2015 Ford Fusion Energi Manual
Page 177 highlights
High Voltage Battery • When both right side quadrant lights are on and the bottom left quadrant is off, the charge is between 50-75 percent. When three quadrant lights are on and the top left quadrant is off, the charge is between 75-100 percent. When all lights on the entire ring are on, the charge is 100 percent. E144781 • • Note: When your vehicle is waiting to charge, the light ring will turn off one minute after displaying the present state of charge. When your vehicle automatically begins charging, the light ring will turn on and display how far along the charge is per the section above. Note: If the system detects a vehicle charging system fault at any point in a charge cycle, the entire light ring will flash continuously for one minute and then turn off. If this happens, unplug the charging coupler and then plug it back into the charge port receptacle. If the problem persists, contact an authorized dealer. You can modify the lighting ring. See Charge Port Light Ring Settings in the MyFord Touch section. See MyFord Touch™ (page 371). Disconnecting the Charging Coupler Note: Do not pull the wall plug from the wall while your vehicle is charging. Doing so may damage the outlet and the cord. 1. Remove the lock from the charging coupler button. 2. Press the button on the charging coupler. 3. While holding the button, remove the charging coupler from the charge port receptacle on your vehicle. 4. Close the charge port door by pressing the indentation on the charge port door. Continue pressing the indentation while the door rotates counterclockwise and closes. HIGH VOLTAGE BATTERY CUTOFF SWITCH The high-voltage shut off operation shuts off power from the high-voltage battery after a collision, or if your vehicle receives a substantial physical jolt. To reactivate your vehicle after either event, perform the following steps: 1. Turn the ignition off. 2. Turn the ignition on. 3. If your vehicle is not powered after this sequence, repeat steps 1 and 2 up to two more times. For vehicles equipped with a push button start system: Press the START/STOP button to turn ignition off. 2. Press the brake pedal and press the START/STOP button. 3. If your vehicle is not powered after this sequence, repeat steps 1 and 2 up to two more times. 1. 174 Fusion/Mondeo (CC7), enUSA