2004 Jeep Liberty Owner's Manual - Page 101

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 101 Parking Lights, Instrument Panel Lights, and Headlights Turn the end cap of the multi-function control lever to the first detent for parking lights and instrument panel lights. Turn to the second detent for headlight operation. To change the brightness of the instrument panel lights, rotate the center portion of the multi-function control lever up or down. High Beam/Low Beam Select Switch Pull the multi-function control lever towards you to switch the headlights to HIGH beam. Pull the multifunction control lever a second time to switch the headlights to LOW beam. The "High Beam Indicator Light" will illuminate when the high beams are on. Passing Light You can signal another vehicle with your headlights by lightly pulling the multi-function control lever toward the steering wheel. This will cause the headlights to turn on at high beam and remain on until the lever is released. The "High Beam Indicator Light" will illuminate when the high beams are on. Turn Signals Move the multi-function control lever up or down and the arrows on each side of the instrument cluster flash to show proper operation of the front and rear turn signal lights. You can signal a lane change by moving the lever partially up or down without moving beyond the detent. If either light flashes at a very fast rate, check for a defective outside light bulb. If an indicator fails to light when the lever is moved, it would suggest that the fuse or indicator is defective. 3