2007 Jeep Commander Owner Manual - Page 124
2007 Jeep Commander Manual
Page 124 highlights
124 UNDERSTANDING THE FEATURES OF YOUR VEHICLE Turn Signals Move the multi-function control lever up or down and the arrows on each side of the instrument cluster will flash to show proper operation of the front and rear turn signal lights. You can signal a lane change by moving the lever partially up or down. Turn Signal Auto-Mode Tap the multi-function control lever once and the turn signal (left or right) will flash 3 times, and automatically turn off. High Beam Switch Pull the multi-function control lever towards you to switch the headlights to "High" beam. The "High Beam Indicator Light" on the instrument cluster will illuminate. Pull the multi-function control lever a second time to switch the headlights to "Low" beam. Passing Light You can signal another vehicle with your headlights by lightly pulling the multi-function control lever toward the steering wheel. This will cause the headlights to turn on at high beam and remain on until the lever is released. Headlight Time Delay There is also a feature that delays turning off the vehicle lights for 30, 60, or 90 seconds after the ignition switch is turned OFF. To activate the headlight delay, the multifunction control lever must be rotated to the "Off" position after the ignition switch is turned OFF. Only the headlights will illuminate during this time. Refer to "EVIC- Customer Programmable Features" in Section 4 to turn this feature "On/Off" or set the time interval.