2009 Jeep Grand Cherokee Owner's Manual - Page 158

156 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) from the HomeLink buttons while keeping the EVIC display in view. For optimal training, point the battery end of the handheld transmitter away from the HomeLink . 3. Simultaneously, press and hold both the chosen HomeLink button and the hand-held transmitter button until the EVIC display changes from "CHANNEL # TRAINING" to "CHANNEL # TRAINED." Then release both the HomeLink and hand-held transmitter buttons. If the EVIC display states "DID NOT TRAIN" repeat Step 3. If the signal is too weak, replace the battery in the original hand-held transmitter. It may take up to 30 seconds, or longer, in rare cases. The garage door may open and close while you train. NOTE: Some gate operators and garage door openers may require you to replace Step 3 with procedures noted in the "Gate Operator/Canadian Programming" section. 4. Press and hold the just-trained HomeLink button. If the channel has been trained, the EVIC display will now state "CHANNEL # TRANSMIT." If the EVIC display still states "CHANNEL # TRAINING" repeat Step 3. NOTE: After training a HomeLink channel, if the garage door does not operate with HomeLink and the garage door opener was manufactured after 1995, the garage door opener may have rolling code. If so, proceed to the heading "Programming A Rolling Code System." 5. PROGRAMMING A ROLLING CODE SYSTEM At the garage door opener motor (in the garage), locate the "learn" or "training" button.