2009 Jeep Grand Cherokee Owner's Manual - Page 302

300 STARTING AND OPERATING NEUTRAL Shift Procedure 1. Key ON, engine off. 2. Vehicle stopped, with foot on brake. 3. Place transmission into NEUTRAL. 4. Hold down the NEUTRAL "pin" switch (with a pen, etc.) for four seconds until the LED lamp by the switch starts to blink indicating shift in progress. The lamp will stop blinking (stay on solid) when the NEUTRAL shift is complete. A "4WD SYSTEM IN NEUTRAL" message will display on the EVIC (Electronic Vehicle Information Center). Refer to "Electronic Vehicle Information Center (EVIC)" in Section 4 of this manual. Neutral Switch 5. Repeat Steps 1 to 4 to shift out of NEUTRAL. NOTE: If shift conditions/interlocks are not met, a "CHECK SHIFT PROCEDURES" message will flash from the EVIC (Electronic Vehicle Information Center). Refer to "Electronic Vehicle Information Center (EVIC)" in Section 4 of this manual.