2009 Jeep Liberty Owner's Manual - Page 169
2009 Jeep Liberty Manual
Page 169 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 167 Place the hand-held transmitter 1-3 in (3-8 cm) away from the HomeLink button you wish to program while keeping the indicator light in view. 3. Simultaneously press and hold both the chosen HomeLink button and the hand-held transmitter button until the HomeLink indicator changes from a slow to a rapidly blinking light, then release both the HomeLink and hand-held transmitter buttons. Watch for the HomeLink indicator to change flash rates. When it changes, it is programmed. It may take up to 30 seconds, or longer in rare cases. The garage door may open and close while you train. NOTE: • Some gate operators and garage door openers may require you to replace Step 3 with procedures noted in the "Gate Operator/Canadian Programming" section. • After training a HomeLink channel, if the garage door does not operate with HomeLink and the garage door opener was manufactured after 1995, the garage door opener may have a rolling code. If so, proceed to the heading "Programming A Rolling Code System." 4. Press and hold the just-trained HomeLink and observe the indicator light. button 3 If the indicator light stays on constantly, programming is complete and the garage door (or device) should activate when the HomeLink button is pressed. If the indicator light blinks rapidly for two seconds, and then turns to a constant light, continue with programming for a Rolling Code. 5. PROGRAMMING A ROLLING CODE SYSTEM At the garage door opener motor (in the garage), locate the "Learn" or "Training" button.