2009 Jeep Liberty Owner's Manual - Page 213
2009 Jeep Liberty Manual
Page 213 highlights
UNDERSTANDING YOUR INSTRUMENT PANEL 211 26. 4WD Indicator - Vehicles Equipped with Selec-Trac II This light alerts the driver that the vehicle is in the full-time four-wheel drive auto mode. In this mode, the system operates with a normal torque split of 42% front axle and 58% rear axle. It can redirect up to 100% of torque to the front or rear axle, if necessary. 27. Odometer/Trip Odometer The odometer shows the total distance the vehicle has been driven. The trip odometer shows individual trip mileage. Refer to "Trip Odometer button" for additional information. NOTE: vehicle vehicle reading U.S. Federal regulations require upon transfer of ownership, the seller certify the mileage the has been driven. Therefore, if the odometer is changed because of repair or replacement, be sure to keep a record of the reading before and after the service so that the correct mileage can be determined. Vehicle Warning Messages When the appropriate conditions exist, messages such as "door" (door ajar), "gATE" (liftgate ajar), "gLASS" (flip-up glass ajar), "gASCAP" (fuel cap fault), "LoW tirE" (low tire pressure), or "CHANgE OIL" will display in the odometer. LoW tirE When the appropriate condition exists, the odometer display will toggle between LoW and tirE for three cycles. NOTE: If the instrument cluster is equipped with the optional Electronic Vehicle Information Center (EVIC), then most warnings will display in the EVIC. 4