2010 Jeep Commander User Guide - Page 36

ELECTRONICS Programming A Rolling Code System • At the garage door opener motor (in the garage), locate the "learn" or "training" button. This can usually be found where the hanging antenna wire is attached to the garage door opener motor (it is NOT the button normally used to open and close the door). • Firmly press and release the "learn" or "training" button. The name and color of the button may vary by manufacturer. Within 30 seconds, return to the vehicle and press the programmed HomeLink® button twice (holding the button for two seconds each time). If the device is plugged in and activates, programming is complete. • If the device does not activate, press the button a third time (for two seconds) to complete the training. Using HomeLink® • To operate, simply press and release the programmed HomeLink® button and the trained device will operate. • Refer to your Owner's Manual on the DVD for further details. If you have any problems programming HomeLink®, or require assistance, please call toll-free 1-800-355-3515, or on the Internet, at www.HomeLink.com. POWER INVERTER • There is a 115-volt, 150-watt power inverter outlet located on the back of the center console. This outlet can power cellular phones, electronics and other low power devices requiring power up to 150 watts. • Press the switch located in the switch bank on the lower instrument panel to turn the power to the outlet on. • Press the switch again to turn the power off. The status indicator of the AC power inverter indicates whether the inverter is producing AC power. NOTE: The power inverter is designed with built-in overload protection. If the power rating of 150 watts is exceeded, the power inverter will automatically shut down. Once the electrical device has been removed from the outlet, the inverter should automatically reset. If the power rating exceeds approximately 170 watts, the power inverter may have to be reset manually. To reset the inverter manually, press the power inverter button OFF and ON. To avoid overloading the circuit, check the power ratings on electrical devices prior to using the inverter. 34