2010 Jeep Commander User Guide - Page 39

ELECTRONICS Changing The Volume • Start a dialogue by pressing the Phone button normal call. , then adjust the volume during a • Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable level while the uconnect™ system is speaking. Please note the volume setting for uconnect™ is different than the audio system. NOTE: To access the tutorial, press the uconnect™ hard-key. After the BEEP, say "tutorial". Press any hard-key or touch the display to cancel the tutorial. VOICE RECOGNITION • The Voice Recognition (VR) system allows you to control your AM, FM radio, satellite , you will radio, disc player, and a memo recorder. When you press the VR button hear a beep. The beep is your signal to give a command. If you do not say a command within a few seconds, the system will present you with a list of options. If you ever wish to interrupt the system while it lists options, press the VR button , listen for the BEEP, and say your command. • Please refer to uconnect™ tunes in the uconnect™ User's Manual on the DVD for further details. Changing The Volume • Start a dialogue by pressing the VR button , then say a command (e.g., "tutorial"). • Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable level while the Voice Recognition system is speaking. Please note the volume setting for Voice Recognition is different than the audio system. WARNING! Any voice commanded system should be used only in safe driving conditions and all attention should be kept on the roadway ahead. Failure to do so may result in an accident causing serious injury or death. . After the BEEP, say "tutorial". NOTE: To access the tutorial, press the VR button Press any hard-key or touch the display to cancel the tutorial. 37