2011 Jeep Compass Owner Manual - Page 18
2011 Jeep Compass Manual
Page 18 highlights
16 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 3. Insert the second valid key into the ignition switch. Turn the ignition switch to the ON/RUN position within 15 seconds. After 10 seconds, a chime will sound. In addition, the Vehicle Security Light will begin to flash. Turn the ignition switch to the LOCK position and NOTE: When having the Sentry Key Immobilizer remove the second key. System serviced, bring all vehicle keys with you to an 4. Insert a blank Sentry Key into the ignition switch. authorized dealer. Turn the ignition switch to the ON/RUN position within Customer Key Programming 60 seconds. After 10 seconds, a single chime will sound. If you have two valid Sentry Keys, you can program In addition, the Vehicle Security Light will stop flashing. new Sentry Keys to the system by performing the To indicate that programming is complete, the Vehicle following procedure: Security Light will turn on again for three seconds and 1. Cut the additional Sentry Key Transponder blank(s) then turn off. to match the ignition switch lock cylinder key code. The new Sentry Key is programmed. The Remote 2. Insert the first valid key into the ignition switch. Turn Keyless Entry (RKE) transmitter will also be prothe ignition switch to the ON/RUN position for at least grammed during this procedure. three seconds, but no longer than 15 seconds. Then, turn the ignition switch to the LOCK position and remove the first key. dealer or by following the customer key programming procedure. This procedure consists of programming a blank key to the vehicle electronics. A blank key is one that has never been programmed.