2011 Jeep Grand Cherokee Owner Manual - Page 214

212 UNDERSTANDING THE FEATURES OF YOUR VEHICLE Gate Operator/Canadian Programming Canadian radio frequency laws require transmitter signals to time-out (or quit) after several seconds of transmission - which may not be long enough for HomeLink௡ to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to time-out in the same manner. 3. Continue to press and hold the HomeLink௡ button, while you press and release ("cycle"), your handheld transmitter every two seconds until HomeLink௡ has successfully accepted the frequency signal. The indicator light will flash slowly and then rapidly when fully trained. If you unplugged the device for training, plug it back in It may be helpful to unplug the device during the cycling at this time. process to prevent possible overheating of the garage Then proceed with Step 4 under "Programming door or gate motor. HomeLink௡," earlier in this section. If you are having difficulties programming a garage door Using HomeLinkா opener or a gate operator, replace "Programming To operate, press and release the programmed HomeLink௡" Step 3, with the following: HomeLink௡ button. Activation will now occur for the trained device (i.e., garage door opener, gate operator, security system, entry door lock, home/office lighting, etc.,). The handheld transmitter of the device may also be used at any time.