2011 Jeep Grand Cherokee Owner Manual - Page 462

460 STARTING AND OPERATING NOTE: When shifting out of transfer case NEUTRAL NOTE: (N), turning the engine OFF may be required to avoid • Steps 1 through 5 are requirements that must be met prior to pressing the NEUTRAL (N) button, and must gear clash. continue to be met until the shift has been completed. 7. Shift the transmission into PARK. If any of these requirements are not met prior to pressing the NEUTRAL (N) button or are no longer 8. Release the brake pedal. met during the shift, the NEUTRAL (N) indicator light 9. Disconnect vehicle from the tow vehicle. will flash continuously until all requirements are met or until the NEUTRAL (N) button is released. 10. Start the engine. • The ignition switch must be in the ON/RUN position for a shift to take place and for the position indicator 12. Release the parking brake. lights to be operable. If the ignition switch is not in the ON/RUN position, the shift will not take place and no 13. Shift the transmission into DRIVE, release the brake position indicator lights will be on or flashing. pedal, and check that the vehicle operates normally. 11. Press and hold the brake pedal. 14. The Keyless Enter-N-Go button (if equipped) may • A flashing NEUTRAL (N) position indicator light indicates that shift requirements have not been met. now be reinstalled if desired. Refer to "Starting Procedures/Keyless Enter-N-Go" in "Starting and Operating" for further information.