2014 Jeep Compass Owner Manual - Page 231

UNDERSTANDING YOUR INSTRUMENT PANEL 229 running, a malfunction has been detected in the ESC 28. 4WD! Warning Light - If Equipped system. If this light remains on after several ignition This light monitors the 4-Wheel Drive (4WD) cycles, and the vehicle has been driven several miles system. The light will come on, for a bulb (kilometers) at speeds greater than 30 mph (48 km/h), see check, when the ignition key is turned to the your authorized dealer as soon as possible to have the ON/RUN position and may stay on for as long problem diagnosed and corrected. as three seconds. NOTE: When lit solid: There is a 4WD system fault. 4WD • The "ESC Off Indicator Light" and the "ESC Activation/Malfunction Indicator Light" come on momentarily each time the ignition switch is turned to ON/RUN. performance will be at a reduced level. Service the 4WD system soon. When blinking: The 4WD system is temporarily disabled due to overload condition. 4 • Each time the ignition is turned to ON/RUN, the 29. Electronic Vehicle Information Center (EVIC) DisESC system will be ON, even if it was turned off play - If Equipped previously. When the appropriate conditions exist, this display • The ESC system will make buzzing or clicking shows the EVIC messages. sounds when it is active. This is normal; the sounds will stop when ESC becomes inactive following the For further information, refer to "Electronic Vehicle Information Center (EVIC)". maneuver that caused the ESC activation.