2014 Jeep Compass Owner Manual - Page 31

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 29 • The engine can be started two consecutive times (two 15-minute cycles) with the RKE transmitter. However, the ignition switch must be cycled to the ON/RUN position before you can repeat the start sequence for a third cycle. To Exit Remote Start Mode Without Driving The Vehicle Press and release the REMOTE START button one time or allow the engine to run for the entire 15-minute cycle. 2 NOTE: To avoid unintentional shut downs, the system Remote start will also cancel if any of the following occur: will disable the one time press of the REMOTE START button for two seconds after receiving a valid Remote • The engine stalls or RPM exceeds 2500 Start request. • Any engine warning lamps come on To Exit Remote Start Mode And Drive The Vehicle • Low Fuel Light turns on Before the end of the 15-minute cycle, press and release • The hood is opened the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if • The hazard switch is pressed equipped). Then, insert the key into the ignition switch • The transmission is moved out of PARK and turn the switch to the ON/RUN position. • The brake pedal is pressed NOTE: The ignition switch must be in the ON/RUN position in order to drive the vehicle.