2014 Jeep Compass Owner Manual - Page 54

52 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 10. To disengage the mini-latch from the mini-buckle for 3. Slide the latch plate upward over the folded webbing. The folded webbing must enter the slot at the top of storage, insert the regular latch plate into the black the latch plate. button on the top of the mini-buckle. The belt will automatically retract to its stowed position. If neces4. Continue to slide the latch plate up until it clears the sary, slide the latch plate down the webbing to allow folded webbing. the belt to retract fully. Insert the mini-latch plate into Seat Belts In Passenger Seating Positions the slot provided in the trim panel. The seat belts in the passenger seating positions are equipped with Automatic Locking Retractors (ALR) Use the following procedure to untwist a twisted lap/ which are used to secure a child restraint system. For shoulder belt. additional information, refer to "Installing Child Re1. Position the latch plate as close as possible to the straints Using The Vehicle Seat Belt" under the "Child anchor point. Restraints" section. The chart below defines the type of feature for each seating position. 2. At about 6 to 12 in (15 to 30 cm) above the latch plate, Driver Center Passenger grasp and twist the belt webbing 180 degrees to create First Row N/A N/A ALR a fold that begins immediately above the latch plate. Second ALR ALR ALR Row Lap/Shoulder Belt Untwisting Procedure