2015 Jeep Compass Owner Manual - Page 186

184 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 3. Without releasing the button proceed with "Program- It may be helpful to unplug the device during the cycling ming A Non-Rolling Code" step 2 and follow all process to prevent possible overheating of the garage door or gate motor. remaining steps. Canadian/Gate Operator Programming 1. Cycle the ignition to the ON/RUN position. For programming transmitters in Canada/United States 2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) that require the transmitter signals to "time-out" after away from the HomeLink® button you wish to program several seconds of transmission. while keeping the HomeLink® indicator light in view. Canadian radio frequency laws require transmitter sig- 3. Continue to push and hold the HomeLink® button, nals to time-out (or quit) after several seconds of transwhile you push and release ("cycle") your hand-held mission - which may not be long enough for HomeLink® transmitter every two seconds until HomeLink® has to pick up the signal during programming. Similar to this successfully accepted the frequency signal. The indiCanadian law, some U.S. gate operators are designed to cator light will flash slowly and then rapidly when time-out in the same manner. fully trained.