2012 Lincoln MKT Owner Guide 1st Printing - Page 153
2012 Lincoln MKT Manual
Page 153 highlights
Locks and Security 5. Turn the ignition back on. The horn will chirp one time to confirm programming mode has been entered and is active. 6. To enable/disable the autolock feature, press the unlock control, then press the lock control. The horn will chirp once if autolock was deactivated or twice (one short and one long chirp) if autolock was activated. 7. Turn the ignition off. The horn will chirp once to confirm the procedure is complete. Autounlock feature (if enabled) The autounlock feature will unlock all the doors when: • the ignition is on, all the doors are closed, and the vehicle has been in motion at a speed greater than 12 mph (20 km/h); • the vehicle has then come to a stop and the ignition is turned off or to accessory; and • the driver door is opened within 10 minutes of the ignition being turned off or to accessory. Note: The doors will not autounlock if the vehicle has been electronically locked after the ignition is turned off and before the driver door is opened. Deactivating/activating autounlock feature Your vehicle comes with the autounlock feature activated; there are three methods to enable/disable this feature: • Through your authorized dealer, • by using a power door unlock/lock sequence, or • by using the instrument cluster message center. Refer to Message center in the Instrument Cluster chapter. Note: The autounlock feature can be activated/deactivated independently of the autolock feature. Power door lock switch autounlock enable/disable procedure Before starting, ensure the ignition is off and all vehicle doors are closed. You must complete Steps 1-5 within 30 seconds or the procedure will have to be repeated. If the procedure needs to be repeated, wait a minimum of 30 seconds before beginning again. 153 2012 MKT (mkt) Owners Guide, 1st Printing USA (fus)