2015 Lincoln MKC Owner Manual Printing 2 - Page 156

Universal Garage Door Opener (If Equipped) 4. Press and hold both the programmed Genie button on the hand-held transmitter and the button you want to program. The indicator light on the visor will flash rapidly when the programming is successful. Note: The Genie transmitter will transmit for up to 30 seconds. If HomeLink does not program within 30 seconds the Genie transmitter will need to be pressed again. If the Genie transmitter indicator light displays green and red, release the button until the indicator light turns off before pressing the button again. Once HomeLink has been programmed successfully, the Genie transmitter must be changed out of program mode. To do this: 1. Press and hold the previously programmed Genie button on the hand-held transmitter for 10 seconds. The indicator light will change from red to red and green. 2. Press the same button twice to confirm the change. If done correctly the indicator light will turn green. Programming HomeLink to the Genie Intellicode Garage Door Opener Motor Note: You may need a ladder to access the garage door opener motor. A E142661 B Red indicator light Green indicator light A. B. 1. Press and hold one of the buttons on the hand-held transmitter for 10 seconds. The indicator light will change from green to red and green. 2. Press the same button twice to confirm the change to programming mode. If done properly the indicator light will appear red. 3. Hold the transmitter within 1-3 inches (2-8 centimeters) of the button on the visor you want to program. E142662 1. Press and hold the program button on the garage door opener motor until both blue indicator lights turn on. 2. Release the program button. Only the smaller round indicator light should be on. 3. Press and release the program button. The larger purple indicator light will flash. Note: The next two steps must be completed in 30 seconds. 153