2015 Lincoln MKC Owner Manual Printing 2 - Page 80

Locks To program additional personal entry codes, repeat Steps 1-3, then for Step 4: • Press 3•4 to save personal code 2. • Press 5•6 to save personal code 3. • Press 7•8 to save personal code 4. • Press 9•0 to save personal code 5. Tips: • Do not set a code that uses five of the same number. • Do not use five numbers in sequential order. • The factory-set code will work even if you have set your own personal code. Recalling Memory Positions The programmed entry codes will recall driver memory positions as follows: • Entry code 1 will recall driver 1 memory positions. • Entry code 2 will recall driver 2 memory positions. • Entry code 3 will recall driver 3 memory positions. Note: Personal entry codes 4 and 5 will not recall memory positions. Erasing a Personal Code 1. Enter the factory-set five-digit code. 2. Press and release 1•2 on the keypad within five seconds. 3. Press and hold 1•2 for two seconds. You must do this within five seconds of completing Step 2. All personal codes will erase and only the factory-set five-digit code will work. Anti-Scan Feature The keypad will go into an anti-scan mode if you enter the wrong code seven times (35 consecutive button presses). This mode disables the keypad for one minute and the keypad lamp will flash. The anti-scan feature turns off after any of the following occur: • One minute of keypad inactivity passes. • You press the unlock button on the remote control. • • You switch the ignition on. You unlocking the vehicle using intelligent access. Unlocking and Locking the Doors To Unlock the Driver Door Enter the factory-set five-digit code or your personal code. You must press each number within five seconds of each other. The interior lamps will illuminate. Note: All doors will unlock if the two-stage unlocking feature is disabled. See Locking and Unlocking (page 67). To Unlock All Doors Enter the factory-set code or your personal code, then press 3•4 control within five seconds. To Lock All Doors Press and hold 7•8 and 9•0 at the same time with the driver door closed. You do not need to enter the keypad code first. 77