2007 Mercedes E-Class Owner's Manual - Page 304

Controls in detail Useful features Step 3: Hold the end of hand-held remote control 5 of the device you wish to train approximately 2 to 5 in (5 to 12 cm) away from the signal transmitter button (2, 3 or 4) to be programmed, while keeping the indicator lamp 1 in view. Step 4: Using both hands, simultaneously press hand-held remote control button 6 and the desired signal transmitter button (2, 3 or 4). Do not release the buttons until step 5 is completed. Indicator lamp 1 will flash, first slowly and then rapidly. Step 5: After indicator lamp 1 changes from a slow to a rapidly flashing light, release the hand-held remote control button and the signal transmitter button. Step 6: Press and hold the just-trained signal transmitter button (2, 3 or 4) and observe the indicator lamp 1. If indicator lamp 1 stays on constantly, programming is complete and your device should activate when the respective signal transmitter button (2, 3 or 4) is pressed and released. Rolling code programming To train a garage door opener (or other rolling code devices) with the rolling code feature, follow these instructions after completing the "Programming" portion (steps 1 through 6) of this text. (A second person may make the following training procedures quicker and easier.) Step 8: Locate "training" button on the garage door opener motor head unit. Exact location and color of the button may vary by garage door opener brand. Depending on manufacturer, the "training" button may also be referred to as "learn"or "smart" button. If there is difficulty locating the transmitting button, refer to the garage door opener Operator's Manual. i If indicator lamp 1 flashes rapidly for about 2 seconds and then turns to a constant light, continue with programming steps 8 through 12 as your garage door opener may be equipped with the "rolling code" feature. i Indicator lamp 1 flashes immediately the first time the signal transmitter button is programmed. If this button has already been programmed, the indicator lamp will only start flashing after 20 seconds. Step 7: To program the remaining two signal transmitter buttons, repeat the steps above starting with step 3. 303