2007 Mercedes E-Class Owner's Manual - Page 331
2007 Mercedes E-Class Manual
Page 331 highlights
Operation Engine compartment Coolant level The engine coolant is a mixture of water and anticorrosion/antifreeze. To check the coolant level, the vehicle must be parked on level ground and the engine must be cool. The coolant expansion tank is located on the driver's side of the engine compartment. Warning! Using a rag, turn cap 2 slowly approximately one half turn counterclockwise to release any excess pressure. Continue turning the cap 2 counterclockwise and remove it. The coolant level is correct if the level: for cold coolant: reaches marking bar 1 in the expansion tank 3 for warm coolant: is approximately 0.6 in (1.5 cm) higher Add coolant as required. Replace and tighten cap 2. For more information on coolant, see the "Technical data" section ( page 498). Do not spill antifreeze on hot engine parts. Antifreeze contains ethylene glycol which may burn if it comes into contact with hot engine parts. Using a rag, slowly open the cap approximately 1/2 turn to relieve excess pressure. If opened immediately, scalding hot fluid and steam will be blown out under pressure. G In order to avoid any potentially serious burns: Use extreme caution when opening the hood if there are any signs of steam or coolant leaking from the cooling system, or if the coolant temperature gauge indicates that the coolant is overheated. Do not remove pressure cap on coolant reservoir if coolant temperature is above 158°F (70°C). Allow engine to cool down before removing cap. The coolant reservoir contains hot fluid and is under pressure. 1 Marking bar in the expansion tank 2 Cap 3 Coolant expansion tank 330