2007 Mercedes S-Class Owner's Manual - Page 330
2007 Mercedes S-Class Manual
Page 330 highlights
Controls in detail Seats ! Do not activate the easy-entry/exit feature if the seat backrest is in an excessively reclined position. Doing so could cause damage to front or rear seats. First move the seat backrest to an upright position. your last set position or to memory position, adjust the seat to the desired position or press and hold the respective memory position button ( page 337). i If the current position for the steering wheel is in the uppermost tilt position, the steering wheel will no longer be able to move upward when the easy-entry/exit feature is activated. If the current seat position falls into a factory-set position range and the system recognizes the current seat position to be rearward enough for easy entry and exit, the driver's seat will not move to the rear when the easy-entry/ exit feature is activated. The adjustment procedure is briefly interrupted when the engine is started. i The last set driver's seat and steering wheel positions are stored when the ignition is switched off the position is stored in memory ( page 336) With the easy-entry/exit feature activated, the steering wheel and driver's seat will return to their last set memory position or a factory-set maximum forward position when you: close the driver's door with the ignition switched on insert the SmartKey into the starter switch or press the KEYLESS-GO* start/stop button ( page 317) once with the driver's door closed. With the easy-entry/exit feature activated the steering wheel tilts upwards and the driver's seat moves a few inches to the rear when you: remove the SmartKey from the starter switch, or open the driver's door with the SmartKey in starter switch position 0 or 1 or the KEYLESS-GO* start/stop button ( page 317) in position 1. Warning! G i For safety reasons, the driver's seat will not return to its last set position with the easy-entry/exit feature activated if the system recognizes the last set position as an extreme forward position. Instead, the driver's seat will remain at or move to a factory-set maximum forward position. To again fully return the driver's seat to Let the system complete the adjustment procedure before setting the vehicle in motion. All driver's seat and steering wheel adjustments must be completed before setting the vehicle in motion. Driving off with the driver's seat/steering wheel still adjusting could cause the driver to lose control of the vehicle. 329
![](/manual_guide/autos/2007-mercedes-sclass-owners-manual-55e1cb1/330.png)