2007 Mercedes S-Class Owner's Manual - Page 416

Controls in detail Driving systems Switch on the ignition ( page 315). Switch on COMAND ( page 79). Move gear selector lever to position R (reverse gear). The COMAND display will show the area behind the vehicle with guide lines to help you reverse into a parking place. This function helps you when you are reversing in a straight line or backing in at any angle. The space required by the vehicle for reversing is shown by guide lines. When you turn the steering wheel to a straight-ahead position, you will see the guide lines on the COMAND display in the following order: This may cause injury to you or others, or damage the vehicle or objects. Mounting tires/rims of other specification than the original equipment tires/rims may impair the function of the Dynamic Rear View Monitor. Contact an authorized Mercedes-Benz Center. Warning! G i If you activate a different function on the driver's COMAND controls while reverse parking or parallel parking, the image from the back-up camera is interrupted. To reactivate the camera, take the vehicle out of reverse gear and then re-engage reverse gear again. Use of Dynamic Rear View Monitor can be dangerous if you are color-blind or have impaired color vision. Only use Dynamic Rear View Monitor if you can see and distinguish all colored guide lines shown by Dynamic Rear View Monitor on the COMAND display. Reverse parking (back-in parking) 1 Yellow and blue guide lines for vehicle width 2 Yellow 13 ft (4 m) guide line 3 Yellow 39 in (1 m) guide line 4 Red 10 in (0.25 m) guide line Switching on Dynamic Rear View Monitor i The Dynamic Rear View Monitor must be activated in the instrument cluster control system in order for it to be switched on ( page 253). 415