2009 Mercury Milan Owner Guide 2nd Printing - Page 62

Lights 7. For ease of bulb socket installation into the lamp assembly, hold the bulb socket at 15 degrees clockwise from a vertical position. Use the two lead wires oriented up to represent the vertical reference position. 8. From the 15 degree position, rotate the bulb socket clockwise to a locked position. 9. Tuck the two lead wires into the lamp housing to assure that they are not pinched when installing the protective rubber cap. 10. Install the protective cap/grill to the housing circular ring by pushing and pressing it forward. 11. Re-apply pressure around the complete circular ring on the housing to make sure the protective cap is completely seated. 12. Reconnect washer bottle filler neck snap strap by reversing step 3 (Passenger side only). 13. Turn the headlamps on and make sure they work properly. If the headlamp was correctly aligned before you changed the bulb, you should not need to align it again. Lowbeam bulb replacement 1. Make sure the headlamp switch is in the off position, then open the hood. 2. Remove the vertical shield from the bolster by disengaging the S-shaped clip and rotating it up in a clockwise direction (Driver side only). 3. Remove the air tube from the air filter assembly (Driver side only). 62 2009 Milan (mln) Owners Guide, 2nd Printing USA (fus)