2009 Mercury Milan Owner Guide 2nd Printing - Page 66
2009 Mercury Milan Manual
Page 66 highlights
Lights 12. From the exterior wheel well area, reach arm through splash shield opening to install bulb socket with new bulb (Passenger side only). 13. Install new bulb socket into the lamp assembly by aligning the indexing fingers, then rotate clockwise to locked position. 14. Reinstall the air tube to the air filter assembly (Driver side only). 15. Reinstall the vertical shield to the bolster (Driver side only). 16. Reinstall the splash shield access panel with screw (Passenger side only). Replacing front side marker bulbs 1. Make sure the headlamp control is in the off position. 2. Pry the lamp away from the vehicle at the rear of lamp at the wheel opening. Rotate lamp from the wheel opening away from the vehicle. As the lamp separates from the vehicle, slide the lamp towards the wheel opening to disengage lamp. 3. Rotate the lamp clockwise while holding the electrical connector in place with your other hand. After rotating the lamp 90 degrees clockwise, pull and disengage the wire harness and bulb from the lamp. 4. With the bulb exposed, carefully remove the bulb from the socket by grasping the bulb and pulling it away from the wire harness. Replace with a new bulb, and reverse the removal steps to complete the process. Replacing stop/tail/turn/and side marker bulbs Your vehicle is equipped with a rear lamp that has a stop/tail/turn/and side marker lamp module containing integral multiple light emitting diodes (LED). If one or more LEDs burn out, the complete lamp module has to be replaced. See your authorized dealer for the replacement LED module. Replacing rear turn signal bulbs 1. Make sure the headlamp switch is in the off position and open the trunk. 66 2009 Milan (mln) Owners Guide, 2nd Printing USA (fus)