2011 Mercury Milan Owner Guide 1st Printing - Page 138

Seating and Safety Restraints WARNING: Do not sit on top of a buckled safety belt or insert a latchplate into the buckle to avoid the Belt-Minder௡ chime. To do so may adversely affect the performance of the vehicle's airbag system. One-time disable If at any time the driver/front passenger quickly buckles then unbuckles the safety belt for that seating position, the Belt-Minder௡ is disabled for the current ignition cycle. The Belt-Minder௡ feature will enable during the same ignition cycle if the occupant buckles and remains buckled for approximately 30 seconds. Confirmation is not given for the one-time disable. Deactivating/activating the Belt-Minderா feature The driver and front passenger Belt-Minder௡ are deactivated/activated independently. When deactivating/activating one seating position, do not buckle the other position as this will terminate the process. Read Steps 1 - 4 thoroughly before proceeding with the deactivation/activation programming procedure. Note: The driver and front passenger Belt-Minder௡ features must be disabled/enabled separately. Both cannot be disable/enabled during the same key cycle. Note: If you are using MyKey™, the Belt-Minder௡ cannot be disabled. Also, if the Belt-Minder௡ has been previously disabled, it will be re-enabled during the use of MyKey™. Refer to MyKey™ in the Locks and security chapter. The driver and front passenger Belt-Minder௡ features can be deactivated/activated by performing the following procedure: Before following the procedure, make sure that: • The parking brake is set • The gearshift is in P (Park) (automatic transmission) • The gearshift is in neutral (manual transmission) • The ignition switch is in the off position • The driver and front passenger safety belts are unbuckled 138 2011 Milan (mln) Owners Guide, 1st Printing USA (fus)