2000 Nissan Altima Owner's Manual - Page 78
2000 Nissan Altima Manual
Page 78 highlights
3. Using both hands, simultaneously push the hand-held transmitter button and the desired HomeLinkா button. Do not release the buttons until step 4 has been completed. NOTE: Some garage door openers may require the procedures noted under ''Canadian Programming''. 4. The HomeLinkா indicator light will flash, first slowly and then rapidly. When the indicator light flashes rapidly, both buttons may be released. The rapid flashing light indicates the Integrated HomeLinkா Universal Transceiver has been successfully programmed. To program the remaining two buttons, follow steps 2 through 4. If, after repeated attempts, you do not successfully program the Integrated HomeLinkா Universal Transceiver to learn the signal of the hand-held transmitter, refer to ''Rolling Code Programming'' later in this section. PROGRAMMING HomeLinkா FOR CANADIAN CUSTOMERS Prior to 1992, D.O.C. regulations required hand-held transmitters to stop transmitting after 2 seconds. To program your hand-held transmitter to HomeLinkா, continue to press and hold the HomeLinkா button (note step 2 through 4 under ''Programming HomeLinkா'') while you press and re-press (''cycle'') your hand-held transmitters every 2 seconds until the indicator light flashes rapidly (indicating successful programming). NOTE: If programming a garage door opener, etc., it is advised to unplug the device during the ''cycling'' process to prevent possible damage to the garage door opener components. SPA0609A PROGRAMMING HomeLinkா 1. With the ignition key in the OFF position, press and hold the two outside buttons, and release when the indicator light begins to flash (approximately 20 seconds). This procedure erases the factory set default codes and does not have to be followed when programming additional hand-held transmitters. 2. Hold the end of the hand-held transmitter (from the device you wish to train) approximately 2 to 5 inches (50 to 127 mm) away from the surface of HomeLinkா keeping the indicator light in view. OPERATING THE INTEGRATED HomeLinkா UNIVERSAL TRANSCEIVER The Integrated HomeLinkா Universal Transceiver (once programmed) may now be used to activate the garage door, etc. To operate, simply press the appropriate programmed Integrated HomeLinkா Universal Instruments and controls 2-31