2000 Nissan Altima Owner's Manual - Page 79

Transceiver button. The red indicator light will illuminate while the signal is being transmitted. bers are located in the Foreword of this owner's manual. PROGRAMMING PROBLEMDIAGNOSIS If the HomeLinkா does not quickly learn the hand-held transmitter information: ● replace the hand-held transmitter batteries with new batteries. ● position the hand-help transmitter with its battery area facing away from the HomeLinkா surface. ● press and hold both the HomeLinkா and hand-held transmitter buttons without interruption. ● position the hand-held transmitter 2 to 5 inches (50 to 127 mm) away from the HomeLinkா surface. Hold the transmitter in that position for up to 15 seconds. If HomeLinkா is not programmed within that time, try holding the transmitter in another position - keeping the indicator light in view at all times. If you continue to have programming difficulties, please contact the NISSAN Consumer Affairs Department. The phone num- CLEARING THE PROGRAMMED INFORMATION Individual buttons cannot be cleared, however to clear all programming, press and hold the two outside buttons and release when the indicator light begins to flash (approximately 20 seconds) To program the Integrated HomeLinkா Universal Transceiver to a garage door opener with the rolling code feature, follow these instructions after completing the ''Programming HomeLinkா'' (the aid of a second person may make the following procedures quicker and easier). 1. Locate the training button on the garage door opener motor unit. Exact location and color of the button may vary by garage door opener brand. If there is difficulty locating the training button, reference the garage door opener Owner's Manual. 2. Press the training button on the garage door opener motor unit (which may activate a training light). NOTE: Following step 2, there are 30 seconds in which to initiate step 3. 3. Firmly press and release the programmed HomeLinkா button. Press and release the HomeLinkா button a second time to complete the training process. (Some garage door openers may require you to do this procedure a third time to complete the training.) ROLLING CODE PROGRAMMING Rolling code garage door openers (or other rolling code devices) which are ''code protected'' and manufactured after 1996, may be determined by the following: A. Reference the garage door opener Owner's Manual for verification. B. The hand-held transmitter appears to program the Integrated HomeLinkா Universal Transceiver but does not activate the garage door. C. Press and hold the trained HomeLinkா button. If the garage door opener has the rolling code feature, the HomeLinkா indicator light will flash rapidly, then remains on after 2 seconds. 2-32 Instruments and controls