2003 Nissan 350Z Owner's Manual - Page 111
2003 Nissan 350Z Manual
Page 111 highlights
Audio main operation Head unit: The tape deck employs a permalloy head which allows for improved reproduction of high frequency ranges. Noise is also greatly reduced by the combined use of the Dolby NR (Noise Reduction) system. The auto loudness circuit enhances the low frequency range automatically in both radio reception and tape and CD playback. ON⋅OFF/Volume control: Turn the ignition key to ACC or ON, and then push the ON⋅OFF/VOL (Volume) control knob while the system is off to call up the mode (radio, tape or CD) which was playing immediately before the system was turned off. When no CD or tape is loaded, the radio will come on. While the system is on, pushing the ON⋅OFF/VOL control knob turns the system off. Turn the ON⋅OFF/VOL control knob to adjust the volume. AUDIO button (BASS, TREBLE, FADER, BALANCE and NR (Dolby)): Press the AUDIO button to change the selecting mode as follows. BASS → TREBLE → FADER → BALANCE → NR (when cassette playing) To adjust Bass, Treble, Fader and Balance, press the AUDIO button until the desired mode (BASS, TREBLE, FADER or BALANCE) appears in the display. Press the TUNE ( , ) or SEEK ( , ) button to adjust Bass and Treble to the desired level. Use the TUNE or SEEK button also to adjust Fader or Balance modes. Fader adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers. To change the NR (Dolby) mode to OFF or ON, press the or (TUNE) button while cassette tape is playing. When Dolby is ON, the display indicates the mark. After 10 seconds, the radio, tape or CD display reappears. Once the sound quality is set to the desired level, press the AUDIO button repeatedly until the radio, tape or CD display appears. Dolby noise reduction manufactured under license from Dolby Laboratories Licensing Corporation. Dolby NR and the double-D symbol are trademarks of Dolby Laboratories Licensing Corporation. Metal or chrome tape usage: The cassette player will be automatically set to high performance play when playing a metal or chrome cassette tape. DISP DISPLAY CHANGE: Push the DISP button for more than 1.5 seconds to adjust the digital clock display. See "Clock" in the "2. Instruments and controls" section for the clock adjustment operation. When the DISP button is pushed for less than 1.5 seconds while the compact disc is being played, the display will show the CD play time. FM-AM radio operation FM/AM band select: Pushing the FM/AM band select button will change the band as follows: AM → FM1 → FM2 → AM When FM/AM band select button is pushed while the ignition switch is in the ACC or ON, the radio will come on at the station last played. The last station played will also come on when the ON⋅OFF/VOL control knob is pushed to ON. If a compact disc or tape is playing when the FM/AM band select button is turned to ON, the compact disc or tape will automatically be turned off and the last radio station played will come on. The FM stereo indicator ST will glow during FM stereo reception. When the stereo broadcast signal is weak, the radio will automatically 4-14 Heater, air conditioner and audio systems