2003 Nissan 350Z Owner's Manual - Page 128

shift mode. Shift range can be selected manually. In the manual shift mode, the shift range is displayed on the position indicator in the meter. Shift ranges up or down one by one as follows: M ¼ When shifting down, move the selector lever to the − (down) side. (Shifts to lower range.) ¼ Moving the selector lever to the same side twice will shift the ranges in succession. However, if this motion is rapidly done, the second shifting may not be completed properly. ¼ In the manual shift mode, the transmission automatically shifts down to 1st gear before the vehicle comes to a stop. When accelerating again, it is necessary to shift up to the desired range. ¼ When canceling the manual shift mode, return the selector lever to the D position. The transmission returns to the normal driving mode. ¼ In the manual shift mode, the transmission may not shift to the selected gear. This helps maintain driving performance and reduces the chance of vehicle damage or loss of control. Fail-safe When the fail-safe operation occurs, the next time the key is turned to the ON position, the warning light will blink for approximately 8 seconds after coming on for 2 seconds. While the vehicle can be driven under these circumstances please note that the gears in the automatic transmission will be locked in 4th gear. If the vehicle is driven under extreme conditions, such as excessive wheel spinning and subsequent hard braking, the fail-safe system may be activated. This will occur even if all electrical circuits are functioning properly. In this case, turn the ignition key OFF and wait for 3 seconds. Then turn the key back to the ON position. The vehicle should return to its normal operating condition. If it does not return to its normal operating condition, have your NISSAN dealer check the transmission and repair if necessary. 1 → ← M 2 → ← M 3 → ← M 4 → ← M 5 M5 (5th): (4th): Use this position for all normal forward driving. M4 For driving up or down long slopes where engine braking would be advantageous. M3 (3rd) and M2 (2nd): Use for hill climbing or engine braking on downhill grades. M1 (1st): Use this position when climbing steep hills slowly or driving slowly through deep snow, sand or mud, or for maximum engine braking on steep downhill grades. ¼ Remember not to drive at high speeds for extended periods of time in lower than M4 range. This reduces the fuel economy. ¼ When shifting up, move the selector lever to the + (up) side. (Shifts to higher range.) Accelerator downshift - In D position - For passing or hill climbing, fully depress the accelerator pedal to the floor. This shifts the transmission down into the lower gear, depending on the vehicle speed. Starting and driving 5-11