2003 Nissan 350Z Owner's Manual - Page 48

temperature displayed on various signs or billboards. momentarily change the display. odometer is also reset at the same time.) Distance to empty (dte - mile or km) The distance to empty (dte) mode provides you with an estimation of the distance that can be driven before refueling. The dte is constantly being calculated, based on the amount of fuel in the fuel tank and the actual fuel consumption. The display is updated every 30 seconds. The dte mode includes a low range warning feature: when the fuel level is low, the dte mode is automatically selected and the digits blink in order to draw the driver's attention. Press the A mode switch k if you wish to return to the mode that was selected before the warning occurred. The dte indicator will remain blinking until the vehicle is refuelled. When the fuel level drops even lower, the dte display will change to (----). NOTE: ¼ If the amount of fuel added while the ignition switch is OFF is small, the display just before the ignition switch is turned OFF may continue to be displayed. ¼ When driving uphill or rounding curves, the fuel in the tank shifts, which may Average fuel consumption (Mpg or l/100 km) The average fuel consumption mode shows the average fuel consumption since the last reset. Resetting is done by pressing the trip computer B setting switch k for more than approximately 1 second. (The average speed is also reset at the same time.) The display is updated every 30 seconds. At about the first 1/3 miles (500 m) after a reset, the display shows (----). Trip odometer (MLS or km) The trip odometer mode shows the total distance the vehicle has been driven since the last reset. Resetting is done by pressing the setting B switch k for more than approximately 1 second. (The elapsed time is also reset at the same time.) Stopwatch (h:m:s) You can use the trip computer as a stopwatch. B Each time the trip computer setting switch k is pressed, the stopwatch will be operated as follows: Average speed (MPH or km/h) The average speed mode shows the average vehicle speed since the last reset. Resetting is B done by pressing the setting switch k for more than approximately 1 second. (The average fuel consumption is also reset at the same time.) The display is updated every 30 seconds. The first 30 seconds after a reset, the display shows (----). After 100 hours, the time will start from the reset display again. Even if the display is switched to the other mode while the time is starting, the stopwatch continues to advance until you stop the time in the stopwatch mode. When the ignition switch is turned OFF, the time is reset. Elapsed time (h:m:s) The elapsed time mode shows the time since the last reset. The displayed time can be reset by B pressing the trip computer setting switch k for more than approximately 1 second. (The trip Tire pressure indicator (PSI) (if so equipped) The tire pressure indicator shows tire pressure (0 - 51 psi) of all wheels (except the spare tire) Instruments and controls 2-9