2004 Nissan Quest Owner's Manual - Page 161

HOW TO USE JOYSTICK AND "ENTER" BUTTON Choose an item on the display using the joystick and push the "ENTER" button for operation. If you do not touch the button or screen key for more than 1 minute on the TRIP, SETTING or START-UP screen, the screen will change to TRIP screen automatically. To proceed to the next step, refer to the separate Navigation System Owner's Manual. HOW TO USE "PREV" BUTTON This button has two functions. ● Go back to the previous display (cancel). If you touch "PREV" button during setup, the setup will be canceled and/or the display will return to the previous screen. ● Finish setup. If you touch this button after the setup is completed, the setup will start over, and the display will return to the climate control or audio mode and Navigation screen. LHA0263 HOW TO USE THE "TRIP" BUTTON When the "TRIP" button is pushed, the following modes will display on the screen. Warning message (if there are any) → TRIP 1 (Elapsed Time, Driving Distance, Average Speed) → TRIP 2 → FUEL ECONOMY (Average Fuel Economy, Distance to Empty) → MAINTENANCE (Engine Oil, Tire Rotation) → OFF. SETTING UP THE START-UP SCREEN When you turn the ignition key to ACC or ON, the SYSTEM START-UP warning is displayed on the screen. Read the warning and select the "I AGREE" (English) or "ENTER" (Français) key then push the "ENTER" button. If you do not push the "ENTER" button, the Navigation system will not proceed to the next step display. Display screen, heater, air conditioner and audio systems 4-9