2004 Nissan Quest Owner's Manual - Page 72
2004 Nissan Quest Manual
Page 72 highlights
● A child restraint with a top tether strap should not be used in the front passenger seat unless the vehicle is the 2 passenger cargo van only. ● The three-point seat belt in your vehicle is equipped with an automatic locking mode retractor which must be used when installing a child restraint. ● Failure to use the retractor's locking mode will result in the child restraint not being properly secured. The restraint could tip over or otherwise be unsecured and cause injury to the child in a sudden stop or collision. WRS0379 WRS0159 Front Facing - step 1 If you must install a child restraint in the front seat, follow these steps: 1. Position the child restraint on the front passenger seat. It should be placed in a front-facing direction only. Move the seat to the rearmost position. Adjust the head restraint to its highest position. Always follow the child restraint manufacturer's instructions. Child restraints for infants must be used in the rear-facing direction and therefore must not be used in the front seat. Front Facing - step 2 2. Route the seat belt tongue through the child restraint and insert it into the buckle until you hear and feel the latch engage. Be sure to follow the child restraint manufacturer's instructions for belt routing. 1-56 Safety-Seats, seat belts and supplemental air bags