2004 Nissan Quest Owner's Manual - Page 187

Audio main operation ON·OFF/Volume control: Turn the ignition key to ACC or ON, and then push the ON·OFF/Volume control knob while the system is off to call up the mode (radio or CD) which was playing immediately before the system was turned off. To turn the system off, press the ON·OFF/Volume control knob. Turn the ON·OFF/Volume control knob to adjust the volume. This vehicle has speed sensitive control volume (SSV) for audio. The audio volume changes as the driving speed changes. AUDIO knob (BASS, TREBLE, FADE, BALANCE and SSV): Press the AUDIO knob to change the mode as follows: BASS → TREBLE → FADE → BALANCE → SSV To adjust Bass, Treble, Fade and Balance, press the AUDIO knob until the desired mode appears in the display. Turn the Tuning knob to adjust Bass and Treble to the desired level. You can also use the Tuning knob to adjust Fader and Balance modes. Fader adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers. To change the SSV mode to OFF, LOW, MID or HIGH, turn the Tuning knob to the right or left. Once you have adjusted the sound quality to the desired level, press the AUDIO knob repeatedly until the radio or CD display reappears. Otherwise, the radio or CD display will automatically reappear after about 10 seconds. Display CD text: To change the text displayed while playing a CD, press the AUDIO knob until "Display Mode" appears. Turn the Tuning knob within 2 seconds. The text will change as follows: Track number ←→ Track title ←→ Disc title ←→ Track number Display satellite radio text (if so equipped): To change the text displayed while listening to satellite radio, press the AUDIO knob until "Display Mode" appears. Turn the Tuning knob within 2 seconds. The text will change as follows: Channel number ←→ Channel name ←→ Artist ←→ Title ←→ Channel number Pause/mute button: To mute or pause the audio sound, push the PAUSE/MUTE button. To release the mute or pause, push the button again. FM/AM/SAT radio operation FM/AM/SAT band select: Pushing the FM-AM or SAT radio select button will change the band as follows: AM ←→ FM or SAT (Satellite- if so equipped) When FM-AM or SAT radio select button is pushed while the ignition switch is in the ACC or ON, the radio will come on at the station last played. The last station played will also come on when the ON·OFF/Volume control knob is depressed to ON. No satellite radio reception is available and "NO SAT" is displayed when the SAT button is pressed unless optional satellite receiver and antenna are installed (retrofit unavailable withouth factory satellite radio pre-wiring), and an XM or SIRIUS™ satellite radio service subscription is active. If a compact disc is playing when the FM-AM or SAT radio select button is pushed, the compact Display screen, heater, air conditioner and audio systems 4-35