2007 Nissan 350Z Owner's Manual - Page 172

Bluetooth wireless connection, the battery power of the cellular phone may discharge quicker than usual. The Bluetooth Hands-Free Phone System cannot charge cellular phones. If the Bluetooth Hands-Free Phone System seems to be malfunctioning, please refer to "Troubleshooting guide" later in this section. You can also visit www.nissanusa.com/bluetooth for troubleshooting help. Refer to the cellular phone Owner's Manual regarding the telephone charges, cellular phone antenna and body, etc. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 8 in (20 cm) between the radiator and your body. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. USING THE SYSTEM The NISSAN Voice Recognition system allows hands-free operation of the Bluetooth HandsFree Phone System. If the vehicle is in motion, some commands may not be available so full attention may be given to vehicle operation. ¼ Wait until the tone sounds before speaking a command. Otherwise, the command will not be received properly. ¼ Start speaking a command within 5 seconds after the tone sounds. ¼ Speak in a natural voice without pausing between words. Initialization When the ignition switch is turned to the ON position, NISSAN Voice Recognition is initialized, which takes a few seconds. When completed, the amber light on the overhead console illuminates and the system is ready to accept button is pushed voice commands. If the before the initialization completes, the system will announce "Hands-free phone system not ready" and will not react to voice commands. Giving voice commands To operate NISSAN Voice Recognition, push button located on the and release the steering wheel. The light on the overhead console flashes to signal you have entered a voice recognition (VR) session. After the tone sounds, speak a command. The command given is picked up by the microphone, and voice feedback is given when the command is accepted. ¼ If you need to hear the available commands for the current menu again, say "Help" and the system will repeat them. ¼ If a command is not recognized, the system announces, "Command not recognized. Please try again." Repeat the command in a clear voice. ¼ If you want to go back to the previous command, you can say "Go back" or "Cor- Operating tips To get the best performance out of the NISSAN Voice Recognition system, observe the following: ¼ Keep the interior of the vehicle as quiet as possible. Close the windows to eliminate surrounding noises (traffic noises, vibration sounds, etc.), which may prevent the system from recognizing voice commands correctly. Display screen, heater, air conditioner and audio systems 4-33