2007 Nissan 350Z Owner's Manual - Page 73

first 30 seconds after a reset, the display shows (----). Elapsed time (h:m:s) and trip odometer (mls or km) Elapsed time: The elapsed time mode shows the time since the last reset. The displayed time can be reset by B pushing the trip computer setting switch k for more than approximately 1 second. (The trip odometer is also reset at the same time.) Trip odometer: The trip odometer mode shows the total distance the vehicle has been driven since the last reset. Resetting is done by pushing the setting B switch k for more than approximately 1 second. (The elapsed time is also reset at the same time.) Even if the display is switched to the other mode while the time is starting, the stopwatch continues to advance until you stop the time in the stopwatch mode. When the ignition switch is turned to the OFF position, the time is reset. Display priority If a low outside air temperature warning, low dte (distance to empty) range warning and low tire pressure warning occur simultaneously, other display modes switch automatically to the outside air temperature display. A When trip computer mode switch k is pressed, the display switches to the mode chosen before the warning display, but the ICY indicator will continue blinking. Up-shift indicator setting (rpm) (for manual transmission models) The up-shift indicator setting mode is used to set the desired engine speed (rpm) for the up-shift indicator (situated in the tachometer) to illuminate. When the engine speed approaches or reaches the set figure, the up-shift indicator will flash or illuminate to show the driver the timing for shifting into a higher gear. See "Driving the vehicle" in the "5. Starting and driving" section for the use of the up-shift indicator. When the up-shift indicator setting mode is selected, the rpm indicator blinks and the engine speed currently set is displayed. (The initial factory setting is 7,500 rpm.) The figure can be changed between 2,000 and 9,000 rpm by B pushing trip computer setting switch k . Pressing the switch for less than approximately 1 second will add the figure by 100 rpm. If pushing for more than approximately 1 second, the figure will increase by 500 rpm. If the battery cable is disconnected, the set engine speed will be returned to the initial figure (7,500 rpm). Stopwatch (h:m:s) You can use the trip computer as a stopwatch. B Each time the trip computer setting switch k is pushed, the stopwatch will be operated as follows: After 100 hours, the time will start from the reset display again. 2-10 Instruments and controls