2007 Nissan 350Z Owner's Manual - Page 180
2007 Nissan 350Z Manual
Page 180 highlights
"Setup" must first delete one phone or replace an existing phone. If you try to pair a phone that has already been paired to your vehicle's system, the system announces the name the phone is already using. The pairing procedure will then be cancelled. When prompted by the system, choose from the following commands: ¼ "New phone" - Refer to "Pairing a phone" earlier in this section. ¼ "Replace phone" - The system announces the names of the phones already paired and asks which you would like to replace. Once you say the name of the phone you wish to replace, the paring procedure will begin. Refer to "Pairing procedure" earlier in this section. ¼ "List phones" - See the description below. B "List phones" k phone of lesser priority when two or more phones paired with Bluetooth Hands-Free Phone System are in the vehicle at the same time. The system asks you to name the phone and confirm the selection. Once the selection is confirmed, the selected phone remains active until the ignition switch is turned OFF or you select a new phone. D "Change priority" k Use the Setup command to change options associated with the Bluetooth Hands-Free Phone System. A "Pair phone" k Use the Change Priority command to change the priority level of the active phone. The priority level determines which phone is active when more than one paired Bluetooth phone is in the vehicle. The system states the priority level of the active phone and asks for a new priority level (1, 2, 3, 4, 5). If the new priority level is already being used for another phone, the two phones will swap priority levels. For example, if the current priority levels are: Priority Level 1 = Phone A Priority Level 2 = Phone B Priority Level 3 = Phone C Use the Pair Phone command to pair a phone to the Bluetooth Hands-Free Phone System. When you are asked to enter a PIN code for pairing your Bluetooth cellular phone, operate it to enter the code "1234". The code is always "1234" regardless of the number of phones paired. Up to 5 phones can be paired. If you try to pair a sixth phone, the system announces that you Use the List Phones command to hear the names of the phones currently paired. If no phones are paired, the system announces, "No paired phones to list." The system then ends the VR session. C "Select phone" k Use the Select Phone command to select a Display screen, heater, air conditioner and audio systems 4-41