2007 Nissan Altima Owner's Manual - Page 111

Auto-reverse function If the control unit detects something caught in the window as it is closing, the window will be immediately lowered. The auto-reverse function can be activated when the window is closed by automatic operation when the ignition switch is in the ON position or for 45 seconds after the ignition switch is turned to the OFF position. Depending on the environment or driving conditions, the auto-reverse function may be activated if an impact or load similar to something being caught in the window occurs. 1. Push the ignition switch to the ON position. 2. Open the window more than halfway by operating the power window switch. 3. Pull the power window switch and hold it to close the window, and then hold the switch more than 3 seconds after the window is closed. 4. Release the power window switch. Operate the window by the automatic function to confirm the initialization is complete. 5. Perform steps 2 through 4 above for other windows. If the power window function does not operate properly after performing the above procedure, see a NISSAN dealer for assistance. LIC0410 Automatic operation To fully open a window equipped with automatic operation, press the window switch down (only driver's side shown) to the second detent and release it; it need not be held. The window automatically opens all the way. To stop the window, lift the switch up while the window is opening. To fully close a window equipped with automatic operation, pull the switch up to the second detent and release it; it need not be held. WARNING There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the window. When power window switch does not operate If the power window automatic function (closing only) does not operate properly, perform the following procedure to initialize the power window system. Instruments and controls 2-43