2007 Nissan Altima Owner's Manual - Page 286

LIGHTS HEADLIGHTS Replacing the xenon headlight bulb (if so equipped) WARNING HIGH VOLTAGE When xenon headlights are on, they produce a high voltage. To prevent an electric shock, never attempt to modify or disassemble. Always have your xenon headlights replaced at a NISSAN dealer. For additional information, see "Headlight and turn signal switch" in the "Instruments and controls" section. ● Do not leave the headlight assembly open without a bulb installed for a long period of time. Dust, moisture, smoke, etc. entering the headlight body may affect bulb performance. Remove the bulb from the headlight assembly just before a replacement bulb is installed. ● Only touch the plastic base when handling the bulb. Never touch the glass envelope. Touching the glass could significantly affect bulb life and/or headlight performance. ● High pressure halogen gas is sealed inside the halogen bulb. The bulb may break if the glass envelope is scratched or the bulb is dropped. ● Use the same number and wattage as originally installed: Low beam: Wattage: 55 Bulb no.: H11* High beam: Wattage: 65 Bulb no.: H9* *: Always check with the Parts Department at a NISSAN dealer for the latest parts information. Fog may temporarily form inside the lens of the exterior lights in the rain or in a car wash. A temperature difference between the inside and the outside of the lens causes the fog. This is not a malfunction. If large drops of water collect inside the lens, contact a NISSAN dealer. FRONT PARK/TURN/SIDEMARKER LIGHT Bulb replacement requires the removal of the headlight assembly. If replacement is required, see your NISSAN dealer. Replacing the halogen headlight bulb The headlight is a semi-sealed beam type which uses a replaceable headlight (halogen) bulb. Because the headlight assembly must be removed from the vehicle for bulb replacement, see your NISSAN dealer. CAUTION ● Aiming is not necessary after replacing the bulb. When aiming adjustment is necessary, contact a NISSAN dealer. 8-26 Maintenance and do-it-yourself