2007 Nissan Murano Owner's Manual - Page 119
2007 Nissan Murano Manual
Page 119 highlights
HomeLink button - releasing when the device begins to activate. 5. If the indicator light on the HomeLink blinks rapidly for two seconds and then turns solid, HomeLink has picked up a "rolling code" garage door opener signal. You will need to proceed with the next steps to train the HomeLink to complete the programming which may require a ladder and another person for convenience. 6. Push and release the training button located on the garage door opener's motor to activate the "training mode". This button is usually located near the antenna wire that hangs down from the motor. If the wire originates from under a light lens, you will need to remove the lens to access the training button. NOTE: Once you have pushed and released the training button on the garage door opener's motor and the "training light" is lit, you have 30 seconds in which to perform step 7. Use the help of a second person for convenience to assist when performing this step. 7. Quickly within 30 seconds of pushing and releasing the garage door opener training button, firmly push and release the HomeLink button you have just programmed. Push and release the HomeLink button up to three times to complete the training. 8. Your HomeLink button should now be programmed. (To program the remaining HomeLink buttons for additional door or gate openers, follow steps 2 through 8 only.) NOTE: Do not repeat step one unless you want to "clear" all previously programmed HomeLink buttons). If you have any questions or are having difficulty programming your HomeLink buttons, please web site at: refer to the HomeLink www.homelink.com or call 1-800-355-3515. SIC3041 3. Using both hands, simultaneously push and hold both the HomeLink button you want to program and the hand-held transmitter button. DO NOT release the buttons until step 4 has been completed. 4. Hold down both buttons until the indicator light on the HomeLink flashes, changing from a "slow blink" to a "rapid blink". This could take up to 90 seconds. When the indicator light blinks rapidly, both buttons may be released. The rapidly flashing light indicates successful programming. To activate the garage door or other programmed device, push and hold the programmed PROGRAMMING HomeLink FOR CANADIAN CUSTOMERS Prior to 1992, D.O.C. regulations required handheld transmitters to stop transmitting after 2 seconds. To program your hand-held transmitter to HomeLink , continue to push and hold the HomeLink button (note steps 2 through 4 under "Programming HomeLink ") while you push and re-push ("cycle") your hand-held transmitter every 2 seconds until the indicator 2-46 Instruments and controls