2009 Nissan GT-R Owner's Manual - Page 86
2009 Nissan GT-R Manual
Page 86 highlights
Setting Push the ignition switch to the ON position. Use the ENTER switch and toggle the vehicle information display to show the SETTING screen. Use the NEXT switch and ENTER switch to go to ALERT > UPSHIFT. The current status of the upshift indicator will be shown on the UPSHIFT screen. Note that the function is set to AUTO as the factory default setting. To change the upshift indicator mode, choose SETTING on the UPSHIFT screen. Set one of the following modes by pushing the NEXT switch , and then push ENTER to complete...AUTO 3,000 to 6,300 RPM (MANUAL) OFF illuminates just before the red zone. When the maximum engine torque is desired: Set the figure at 5,200 RPM. The green indicator starts flashing from approximately 4,700 RPM and illuminates at 5,200 RPM. When breaking-in the vehicle: To help avoid high engine speeds during breakin, set the upshift indicator to less than 3,500 RPM. The green indicator starts flashing approximately 500 RPM before the set figure and illuminates from the set figure. ( "BREAK-IN SCHEDULE" page 5-32) NOTE: . There may be a slight difference between the timing of the upshift indicator illumination and the tachometer indication. When the battery terminal is disconnected, the set memory will be erased and the mode returns to the default. . The number will increase by 100 RPM. To increase the number by 500 RPM, push and hold the NEXT switch . Example When the maximum engine speed is desired: Set the upshift indicator to AUTO. The yellow indicator illuminates approximately 700 RPM before the red zone, and the red indicator Instruments and controls 2-9