2009 Nissan Murano Owner's Manual - Page 123
2009 Nissan Murano Manual
Page 123 highlights
1 , CLOSE operation, push either of the OPEN * 2 or UP * 5 of the switch. * Tilting moonroof To tilt up the moonroof, push the moonroof 5 . switch to the up position * To tilt down the moonroof, push the switch to the 5 or push the CLOSE side * 2 of up position * the switch. When the moonroof is tilted up, push the CLOSE side of the moonroof switch to the 4 . The moonroof will tilt down second detent * and the sunshades will close. the moonroof and sunshades are closed by automatic operation when the ignition switch is in the ON position or for about 45 seconds after the ignition switch is pushed to the OFF position. If the moonroof and sunshades cannot be closed automatically when the auto reverse function activates due to a malfunction, push 2 of the moonroof and hold the CLOSE side * switch. Depending on the environment or driving conditions, the auto reverse function may be activated if an impact or load similar to something being caught in the moonroof occurs. moonroof switch for 10 seconds. 5. The moonroof and sunshades will fully open and then close. 6. Check if the moonroof switch operates normally. If the moonroof does not operate properly after performing the procedure above, have your vehicle checked by a NISSAN dealer. Auto reverse function WARNING There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the moonroof. If the control unit detects something caught in the moonroof and sunshades when they are closing, the moonroof will be immediately opened. The auto reverse function can be activated when If the moonroof does not operate If the moonroof does not operate properly, perform the following procedure to initialize the moonroof operation system. 1. If the moonroof is open, close it fully by 2 of the moonpushing the CLOSE side * roof switch. 2. Push and hold the CLOSE side moonroof switch. 2 * of the 3. Release the moonroof switch after the moonroof or sunshade moves slightly to the closed position. 4. Push and hold the CLOSE side 2 * of the Instruments and controls 2-53