2009 Nissan Murano Owner's Manual - Page 160

AUTOMATIC DRIVE POSITIONER (if so equipped) The automatic drive positioner system has two features: . . Entry/exit function Memory storage canceled by pressing and holding the SET switch for more than 10 seconds. The indicator lights on the memory switches (1 and 2) will blink once when the function is canceled, and the indicator lights will blink twice when the function is activated. Note that the indicator lights may illuminate after 5 seconds while holding the SET switch. This indicates readiness for linking the Intelligent Key to a stored memory position. Keep the SET switch pressed for more than 10 seconds to turn on or off the entry/exit function. The entry/exit function can also be activated or canceled if the "Lift Steering Wheel on Exit" key or "Slide Driver Seat Back on Exit" key is turned to ON or OFF in the "Comfort & Conv." settings. (See "VEHICLE INFORMATION AND SETTINGS" in the "4. Monitor, heater, air conditioner, audio, phone and voice recognition systems" section.) SPA2445 ENTRY/EXIT FUNCTION This system is designed so that the driver's seat and steering column will automatically move when the selector lever is in the P (Park) position. This allows the driver to get into and out of the driver's seat more easily. The driver's seat will slide backward and the steering wheel will move up when the driver's door is opened with the ignition switch in the LOCK position and the key not inserted in the key port. The driver's seat and steering wheel will return to the previous positions when the ignition switch is pushed to the ACC position. The driver's seat will not return to the previous positions if the seat or steering adjusting switch is operated when the seat is at the exit position. MEMORY STORAGE Two positions for the driver's seat, steering column and outside mirrors can be stored in the automatic drive positioner memory. Follow these procedures to use the memory system. 1. Move the selector lever to the P (Park) position. 2. Push the ignition switch to the ON position. 3. Adjust the driver's seat, steering column and outside mirrors to the desired positions by manually operating each adjusting switch. For additional information, see "SEATS" in the "1. Safety - Seats, seat belts and supplemental restraint system" section and Initialize entry/exit function If the battery cable is disconnected, or if the fuse opens, the entry/exit function will not work though this function was set on before. In such a case, after connecting the battery or replacing with a new fuse, open and close the driver's door more than two times after the ignition switch is turned from the ON position to the LOCK position. The entry/exit function will be activated. Cancel or activate entry/exit function The selector lever must be in the P (Park) position with the ignition switch in the OFF position after the driver's door is opened. The entry/exit function can be activated or 3-30 Pre-driving checks and adjustments